1986 Dodge ram 250 4x4 for sale by owner - Candler, NC - craigslist (2024)

A STRONG TRUCK and good hauling/towing truck for a trailer. It had a 5th wheel ball in the center of the long bed when I bought it 20 years ago and I removed the ball and covered the hole but the hole and reinforcing plate are still there if wanted.
HAVE GOOD NC TITLE WITH NO LIENS, AND NO NC INSPECTION REQUIRED SINCE MORE THAN 30 YEARS OLD.

DODGE VINTAGE PARTS==Also have many mostly original extra Dodge parts from 1970's-1980's Dodge trucks and vans to go along [I owned 7 Dodge vans and trucks since 1973 to present and also collected original parts over the years from other older Dodge trucks and vans]. Most will fit this 1986 Dodge truck. Some parts are new, some used.

I WILL SELL ALL EXTRA DODGE PARTS SEPARATELY FOR$1000. IF WANTED] and then lower the price of the truck.

PARTS LIST==2 exhaust manifolds, 3 tailpipes, brake lines, speedometers for vans and truck, speedometer cable, Rochester quadrajet carburator, windshield wiper motor and assembly, starter motor, master cylinder with vacuum booster, complete wiring harness for 80's Dodge truck, wiring for lights with sockets, wheel bearings new, flywheel, clutch kit, radiator and hood, power steering unit, brake pads, distributor, master cylinder, 4 tie rod ends and ball joints, two 4WD yokes with u-joint, waterpump, fan clutch, instrument cluster, heat/climate control, brake proportioning valve, 2 electronic control units, door hinge, engine gaskets, relay, heat sensor, ballast resistor, many fan belts and hoses, ported vacuum switch, lighter assembly, fan extension, radiator caps, cruise control arm, air filters,taillights and sidelights, door arm rest, rubber door liners, windshield wiper arm, light switch, fuel pump pipe, fuses, engine hood latch, ignition switch unit with keys, muffler clamps and hangers, exhaust shields, 2 voltage regulators, 2 stainless rear view mirrows, horn assembly, 3 chrome door handles with hardware, right and left distributor run pickup and start pickup units with connectors, u-joint for main driveshaft, 2 rotors, door pin and hardware, high/low beam headlight floor control,steel timing chain and gear, and misc. smaller parts, etc.

WILL SELL THE 1986 DODGE TRUCK+ 6 TIRES + 6 RIMS + AND ALL LISTED EXTRA DODGE PARTS FOR $7600. WILL CONSIDER INTERESTING PARTIAL TRADES.
ALSO==Owner may offer to a qualified buyer free owner financing with $3000. down and I will carry the balance with no fees or interest for 6 months, or for 1 year with $6000. down.
Truck runs good. Most of this truck is original, including the interior,[so probably a good candidate for show quality restoration], but does have smaller dents at the back on driver's side. Truck and all parts are located in Candler, N.C., just west of Asheville, N.C.

Please call Dave at show contact info or show contact info and email me at address above with questions or to set up a time to see the truck. Thank you.

KEY WORDS= Dodge, dodge parts, dodge ram, Dodge truck, Dodge Power ram, vintage dodge truck, vintage auto parts, vintage dodge auto parts